![]() Its not just the Config.sys, but also Autoexec.bat that I suggested you try on the boot floppy. ![]() cab files to the hard drive and run setup from there.ĭid you try any of that? Its important you give me the info I'm looking for so that I can help. Not sure if your cd drive will become available then. If you boot from the floppy, assuming this hard drive is partitioned and formatted, you can run the command SYS C. These will only be hard drive letters, so the next available letter should be the cd drive.Ī little research shows that this was a common problem with that particular laptop. I think the pertinent command here is LH C:\MSCDEX /D:TOSCD001 /M:10. If you do edit those two files, you would of course leave out the number preceding each line.Ĭan you tell us where you got this boot disk? What does it contain? If it contains FDisk, from the A:\> prompt run FDisk /status to see how the drive letters are assigned. Perhaps if you edit the ones on the floppy to contain those commands it might work. This webpage from Toshiba describes the Config.sys and Autoexec.bat files you would need to run that laptop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |